Share
Results 1 to 2 of 2

Thread: The Plasma air pressure low sensor on the front panel

  1. #1

    Default The Plasma air pressure low sensor on the front panel

    We've had a few calls telling us the air pressure sensor light is on, on the front panel.

    On the 2009 models, the light came on to warn you air pressure was too low and it would not allow you to use the cutter. The manual reflects this.

    On the 2010 units, the light is on to let you know the air pressure is in range.

    A simple test. If you turn the air pressure under 25-30PSI and LED/light status changes, the sensor is working and you are fine cutting with the unit.

    Either way, if you're not in range the cutter will not allow you to cut and protect the unit.
    Mike R.
    Email: everlast@us-it.net
    www.everlastgenerators.com
    www.everlastwelders.com
    877-755-9353 x203
    M-F 12 - 7PM PST
    FYI: PP50, PP80, IMIG-200, IMIG-250P, 210EXT and 255EXT.

  2. #2

    Default

    Yes, and SOME of the 2009 models did as well the way the 2010 models do. Some may not have operated this way. But the manual was written prior to the final versions being offered, and was not corrected as the earliest units were originally spec'd this way.

    Basically though, if you see Green, your good. Yellow, red or nothing is not so good.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •